3 responses to “ALG AK triggers – Shot Show 2017”

1. 

   Lawrence Otwell

   October 12, 2017

   Rob, in several videos you’ve mentioned smoothing out the “hump” on the ALG trigger. I put an ALG in my WASR and it functions fine/feels good but my bolt carrier tail hits squarely on the hump and it’s causing minor peening. Can you post a picture showing where and how much material you are typically removing from the “hump” and comment on how you remove it (hand file, Dremel, etc.)? Would like to avoid damaging heat treating.

   Reply
   1. 

      Rob Ski

      October 15, 2017

      You should remove just little bit and simply round it off. That’s it. For some strange reason i can’t post picture into my reply….

      Reply
      1. 

         Lawrence Otwell

         October 15, 2017

         Thx, wouldn’t a collaboration resulting in an ALG AKOU Trigger coming to market be an intriguing concept? Bet it would sell.

         Reply